1. This paper proposes a new method of using a plane wall jet destroying densitycurrent.
本文提出了利用水平附壁射流破除异重流的新方法。
来自互联网
2. The equations of calculating the interface of thermal density current were also presented.
文中给出了温差异重流交界面计算的方程组。
来自互联网
3. The dynamic factors of saltwater intrusion are the tidal flood current, land - ward densitycurrent and mixing.
涨潮流、向陆的密度流和混合是产生盐水入侵的动力因子。
来自互联网
4. The dynamic factors of saltwater intrusion are the tidal flood current, the land-ward densitycurrent and mixing.
张潮流、向陆的密度流和混合是产生盐水入侵的动力因子。
来自互联网
5. Using density current to eject sediment is one of the most effective methods for both prolonging reservoir working life and saving the limited water resource.
运用异重流对水库进行排沙是延长水库寿命并节约清水资源的行之有效的重要方法。
来自互联网
6. The density current of turbid water is the basic characteristic of the water current in sedimentation tank, in both the high turbid water and the general turbid water.
浑水异重流是沉淀设备中水流的基本特征，不仅存在于高浊度水沉淀池中，也存在于一般浊度水的沉淀设备中。
来自互联网
7. Since 2004, Yellow River Conservancy Commission has conducted large-scale prototype testing of artificial density current for sediment ejection and obtained valuable primary data.
自2004年开始，黄委在小浪底水库进行大规模的人工塑造异重流排沙的原型试验，取得了宝贵的原始资料。
来自互联网
8. The new material has such high energy density because it can operate at a higher voltage than current electrode materials and also store more lithium ions.
9. In 10 of the 12 countries studied, current pre-service training is insufficient to maintain the existing density of health workers once all causes of attrition are taken into account.
10. In the simplest setup, the size of the current reveals the density of electrons in the surface, allowing it to be mapped out.
在这个最简单的装置里，电流的大小表明了样品表面电子的密度，并能绘制出来。
来自互联网
11. Any plating must have a can produce normal coating the currentdensity range.
任何电镀都必须有一个能产生正常镀层的电流密度范围。
来自互联网
12. Along with the increase of the currentdensity, cathode polarization effect, coating grain with increasing more and fine.
随着电流密度的增加﹐阴极极化作用随着增加﹐镀层晶粒越来越细。
来自互联网
13. In general, the Lord salt concentration, temperature increase coating, and under the condition of mixing, can allow the more currentdensity.
一般情况下﹐主盐浓度增大﹐镀层温度升高﹐以及有搅拌的条件下﹐可以允许采用较大的电流密度。
来自互联网
14. A superconductor's transition temperature and critical currentdensity are two commonly measured parameters.
超导体的转变温度和临界电流密度是两个经常要测量的参数。
来自互联网
15. The results show that the grain size of tin gradually gets smaller while that of alloy layer gets bigger and bigger with the increasing of current density.
结果表明，随着电流密度的增加，电沉积的锡晶粒度逐渐细化，合金层的晶粒度有变粗的趋势。
来自互联网
16. Electroplating working conditions is to point to the operation of the when electroplating changes factors, including: currentdensity, temperature, mixing and power of the wave, etc.
电镀工作条件是指电镀时的操作变化因素，包括：电流密度、温度、搅拌和电源的波形等。
来自互联网
17. Currentdensity: unit under the plating area under current, usually the higher current density film thickness is thicker, but is high coating will scorched thick dry.
电流密度：单位电镀面积下所承受的电流，通常电流密度越高膜厚越厚，但是过高时镀层会烧焦粗燥。
来自互联网
18. When the currentdensity is too low, the cathode polarization effect, smaller coating, not even orange crystal bulky coating.
当电流密度过低时﹐阴极极化作用较小﹐镀层桔晶粗大﹐甚至没有镀层。
来自互联网
19. Tunneling process is important in the low to moderate currentdensity range.
在中等电流密度下，隧道穿透过程是重要的。
来自互联网
20. In accordance with the liquid temperature selection in winter, currentdensity, summer with the lower limit.
依液体温度选择电流密度，冬季用下限，夏季用上限。
来自互联网
21. Furthermore the distribution and variation of the electrostatic potential and layer ionospheric currentdensity at the northern hemisphere are calculated by the dynamo theory.
继而从发电机理论得到了电离层电位及层电流密度在北半球的分布和变化。
来自互联网
22. Reasonable matching of wafer and wire: the advanced matching of wafer improves average voltage in electric field and currentdensity of wafer corona, which the dedusting efficiency is higher.
板线匹配更合理。先进的板匹配，有效地提高了电场平均电压和板电晕电流密度，收尘效率更高。
来自互联网
23. The results show that there exists a density window for lower hybrid wave current drive (LHCD), i. e, LHCD would be achieved only within a certain range of plasma density.
25. The change of the currentdensity of the upper and lower specification limits by plating solution is the nature of concentration, temperature and stirring, factors such as the decision.
电流密度的变化的上限和下限是由电镀液的本性﹐浓度﹐温度和搅拌等因素决定的。
来自互联网
26. Operating currentdensity is too low, leading to low current area, coating can't exhalation.
操作电流密度太低，导致低电流区，镀层无法析出。
来自互联网
27. Reduce the currentdensity.
降低电流密度。
来自互联网
28. The results show that CO2 transfer rate increases with increasing electrical currentdensity and CO2 concentration difference across the membrane.
解的结果表明： 影响CO2传质通量的因素主要有电流密度及CO2在膜两侧的浓度差。
来自互联网
29. The results show that CO2 transfer rate increases with increasing electrical currentdensity and CO2 concentration difference across the membrane.
