1. And in these bearings here are shaft encoders, and they sense that the rotation that the outer housing makes in order to keep this thing pointing at the same direction.
在这些轴承中,有轴角编码器,它们感受到了外面的框的转动,来保持这个东西,指向相同的方向。

来自互联网

2. These use a central shaft with sliding vanes inside a housing of decreasing radius.
这些使用一根中心的轴由于在一个减少半径的住房里面滑动风向标。

来自互联网

3. The bearings are generally installed with a small axial clearance in order to compensate for length variations of shaft and housing.
轴承一般设一个小轴向间隙,以弥补轴和轴承座的长度变化。

来自互联网

4. Mount gearbox on housing, assuring that coup ling key slot accepts gearbox shaft key properly.
在壳体上安装齿轮箱,确保齿轮箱轴键妥当地固定在耦合键槽中。

来自互联网

5. To gain satisfactory support both the shaft shoulders as well as the housing shoulders must have a certain minimum height.
为了获得令人满意的支持轴肩,以及住房肩膀,必须有一定的最低高度。

来自互联网

6. The motor housing encloses the armature and pole pieces, holds the bearings that support the armature shaft, and provides the terminals for connecting the motor to the rest of the staring system.
启动机外壳内装入电枢与磁极,外壳两端的轴承支撑电枢转轴,并将启动机与启动系统支架相连。

来自互联网

7. The needle roller clutch bearing is a kind of compound function bearing which transmits torque between the shaft and housing in one direction and allows free overrun in the opposite direction.
滚针离合器轴承是可单向传递轴和轴承座之间的扭矩,而反方向允许自由转动的一种复合功能轴承。

来自互联网

8. The motor housing is flange-mounted, along with a drive shaft mounted therein, to the gear housing.
该马达外壳通过支承在其中的驱动轴法兰连接在变速箱外壳上。

来自互联网

9. The results show that stress in hollow beam and semi-shaft bush is much less than permissible stress, while joint of suspension frame and axle housing has too large local stress.
结果表明,驱动桥壳空心梁和半轴套管部分的应力远小于材料的许用应力,而悬架支座与桥壳连接处出现了局部应力过大的情况。

来自互联网

10. It consists of a bored housing that contains a throttle plate that rotates on a shaft.
它由一个无聊的房子,包含一个节流板轴上旋转。

来自互联网

11. They limit the axial displacement of shaft or housing ir one direction.
它将轴或支架的轴向移动控制在一个方向。

来自互联网

12. An earth shovel device composed of two shaft seats, a short shaft and an earth shovel plate fixed on the short shaft is fixed on a housing close to the upper shaft.
在靠近上轴的壳体上固定有由二个轴座,短轴及固定在短轴上的铲土板组成的铲土装置。

来自互联网

13. A penthouse can be an apartment on the roof or top floor of a Building or a structure on the roof housing the top of an elevator shaft, air-conditioning equipment, or stairs leading to the roof.
阁楼可以是公寓屋顶部分,也可以是建筑物的顶层,或是用作电梯井或楼梯井的顶部或安装空调设备的建筑。

来自互联网

14. Thrust ball bearings consist of ball, retainer and both shaft and housing washers which contain grooves for the ball.
推力球轴承包括球,保持架和两轴和轴承座垫圈其中所包含的球槽。

来自互联网

15. The shaft and the bearing's inner race rotate together, while the outer race and the transmission's housing are stationary.
轴和轴承地内圈扭转在一同,而外圈和传输地住房是固定地。

来自互联网

16. The propeller on the propeller shaft is located outside the rudder propeller housing.
螺旋桨轴上的螺旋桨位于所述舵桨壳体的外部。

来自互联网

17. The inner race is keyed to the shaft. The outer race has h7 tolerance and should be fitted in housing with a k7 tolerance. Additional side notches provide for positive torque transmission.
内环与轴用键联接,外环尺寸公差为h 7与公差为h7的机壁配合,外环两侧端面键用于固定外环与机壁以传递扭矩。

来自互联网

18. A scraper is arranged on the main shaft and at the site of the discharge port of the housing.
在主轴上且位于壳体的出料口处设有刮刀。

来自互联网

19. The desiring installation method of installing insert ball bearing unit is: first install the housing at support base firmly, then tighten the bearing to the shaft.
安装带座外球面球轴承时,将轴承套在轴上,先将轴承座牢固地固定在支承面上,然后将轴承紧固在轴上即可。

来自互联网

20. The desiring installation method of installing insert ball bearing unit is: first install the housing at support base firmly, then tighten the bearing to the shaft.
安装带座外球面球轴承时,将轴承套在轴上,先将轴承座牢固地固定在支承面上,然后将轴承紧固在轴上即可。

来自互联网