1. The tapping torquetest is a real cutting test, it has a good relativity with cutting process.
攻丝扭矩模拟评定试验方法为真正的切削试验，与切削加工的相关性较强。
来自互联网
2. Using wireless short range remote control test and power supply technology, the paper develops dynamic torquetest apparatus.
采用无线近程遥测技术，无线供电技术，研制了动态扭矩测试仪。
来自互联网
3. Finally, two methods of laboratory simulation tests on universal machine tools and the tapping-torque test method are introd...
介绍了两种在通用机床上进行的模拟切削试验方法以及攻丝扭矩模拟评定试验机。
来自互联网
4. The regulations and methods for valve base seal test, valve seal test, valve strength test, long term valve test, fatigue test and operating torquetest were summed up in this article.
5. The test program will operate the permanent magnet propulsion motor up to full power (full torque and full load) in a test facility that simulates an actual U.S.Navy DDG-1000 engine room.
6. The test program will operate the permanent magnet propulsion motor up to full power (full torque and full load) in a test facility that simulates an actual U.S. Navy DDG-1000 engine room.
7. If this two has been achieved, you should do a test drive to enjoy the acceleration and torque.
如果这两个已经实现，你应该做一个测试驱动器，享受加速和扭矩。
来自互联网
8. This system can complete the engine rotational speed and torque high accuracy control and the test, also engine temperature, pressure, oil consumption parameters survey.
本系统能够完成发动机的转速、转矩的高精度控制与测试，以及发动机温度、压力、油耗等指标参数的测量。
来自互联网
9. Connect the test cable and tighten to specified torque with a torque wrench.
连接上测试电缆，并用一个扭矩扳手紧固到指定的扭矩。
来自互联网
10. The engineering setting methods of the torque loaded by dynamometer on vehicle exhaust test under driving mode condition are researched.
研究了工况法汽车排放测试中测功器加载扭矩的设定及其工程实现的方法。
来自互联网
11. Prior to hydro test, check torque values again and bring them up to the torque value shown in the Bolting Specification table.
在进行水压测试之前，要再次检查扭矩值，确保扭矩达到螺栓规格表上显示的扭矩值。
来自互联网
12. The effect of clean automobile fuel-LPG on power and torque of electric injector engine has been studied by bench scale test in this paper.
通过发动机台架试验，研究了清洁汽车燃料——LPG对电喷发动机功率和扭矩的影响。
来自互联网
13. A test method of torque synchro rotor quadrature axle damping short-loop loss and current was introduced.
介绍力矩式自整角机转子交轴阻尼短路环损耗和电流的一种测试方法。
来自互联网
14. Bending (torque) test was also performed to evaluate strength of the brazed joints.
为了评价焊接强度，还进行了抗弯强度(扭矩)测试。
来自互联网
15. Apply wheel torque sensor to develop the test system of tire rolling resistant force.
应用车轮扭矩传感器开发了轮胎滚动阻力测试系统。
来自互联网
16. The torque loss model proposed in this paper is supported by experimental data from several different test procedures.
本文中采用几种不同的试验方法提供的实验数据推荐了转矩损失的数字模型。
来自互联网
17. Based on a turboshaft engine test data gathered during cold run, a method of calculating engine resistant torque and torque for acceleration was introduced.
依据某型涡轴发动机冷运转试验数据，给出了发动机阻力矩和净力矩的计算方法。
来自互联网
18. The test program will operate the permanent magnet propulsion motor up to full power (full torque and full load) in a test facility that simulates an actual U. S. Navy DDG-1000 engine room.
19. The PLC is used in automatic pressure surge control, oil temperature control, product test control, and automatic measurement of pressure, flow, temperature, speed, torque, etc.
20. The application of ABB ACS800 direct torque control (DTC) frequency-variable speed control system in the reducer loading test was presented.
介绍应用abb公司的ACS800直接转矩控制(DTC)变频调速控制系统具体实现减速机性能的测试。
来自互联网
21. The specifications for seat sealing test, body sealing test, body strength test, valve long term test, fatigue strength test and operation torque of plastic valves were summarized.
22. Based on CVT and its test development system, the study and test ofthe optical-electronic torque sensor is given in this dissertation.
全文立足于CVT和其试验开发系统，重点介绍了用于CVT 的光电扭矩传感器系统的研制和试验。
来自互联网
23. The essential theory of the mechanical characteristic test of the wiper motor without torque and speed sensors is discussed in this paper.
论述了无转速转矩传感器的刮水器电动机机械特性测试基本原理；
来自互联网
24. In the test, the computer data collection system has been applied to measure rolling force, torque and power in rolling procession.
实验中对轧制压力、轧制扭矩、轧制功率进行了测试，并将单头和双头模具所测得的结果进行了比较与分析。
来自互联网
25. The torque and fuel consumption model of engine JL474Q1 has been built up based on the engine test.
对JL 474Q1发动机进行性能试验，在实验数据的基础上构造发动机转矩模型和发动机燃油消耗模型。
来自互联网
26. Measures to prevent cylinder head nut from loosing has been discovered based on the test and study of the torque of cylinder head nuts for 4125 diesd engine.
通过对4125柴油机气缸盖螺母拧紧扭矩的试验研究，找到了气缸盖螺母防松的措施。
来自互联网
27. Having taken test and theoretical quantitative analysis, various rules of grasping resistance torque and grasping resistance have been obtained.
通过试验和经过理论的定量分析，获得了各种情况的抓取阻力矩和抓取运动阻力的规律。
来自互联网
28. This System is designed to test the transmission 'clearance and driving torque and cut strength displacement in some kind of rudderpost automatically.
本系统设计实现对某型号舵轴的传动间隙、驱动转矩以及剪切力位移的自动化测量。
来自互联网
29. At the same time, experimental test of samples show at its output torque increases 80% in contrast with the same type motor.
30. Verify the functions through the test platform developed by our team, which takes the DSP processor as the core to realize PMSM start-up at maximum torque and without mechanical impact.
