1. So we're going to load it up to the point that it will break, and that allows us to measure the ultimate tensile strength.
我们将继续装物体,直到断裂点，这样我们就能测量到,极限抗拉强度的大小。
来自互联网
2. Textile conveyor belts - Full thickness tensile testing - Part 1: determination of tensile strength, elongation at break and elongation at the reference load.
织物传送带。全厚度拉伸试验。第1部分：拉伸强度、断裂伸长率和标准负荷下伸长率的测定。
来自互联网
3. The load coefficient method of bolt on tensile strength calculation was improved.
对螺栓拉伸强度计算的载荷系数法作了进一步改进。
来自互联网
4. In calculation, adopted load-unload criterion of stress wave propagation was to decide load-unload state of element and to adjusts and transfers internal stress for tensile failure element as well.
5. And elementary researches have been made in identifying axial tensileload, for which reason more proper identifying purpose has been gained compared with piezoelectric wafers.
并利用压电智能夹层进行了初步的拉伸载荷识别，同压电片相比，识别效果更明显。
来自互联网
6. The failure mechanism and mechanical property of a brittle composite matrix, reinforced with short fibers under the uniaxial tensileload, have been studied.
研究短纤维增强脆性基复合材料在单轴拉伸荷载下的力学性能和破裂机理。
来自互联网
7. Research results: Under the same load condition, the tensile stress of ballastless track slabs without close connected is bigger than that of slabs with close linkage structure.
8. The methods of creep test to get both curves of tensile creep rupture load vs time and creep strain vs time are compared. The procedures to extrapolate the two types of creep curves are presented.
10. The displacements, the depth of tensile stress zone and the maximum value of tensile stress under the complex load were calculated.
计算出了双重荷载作用下的位移量、拉应力区的深度及最大拉应力值。
来自互联网
11. Can a bending load makes both compressive and tensile stress in a member?
弯曲载荷可以对一个物件同时产生压缩应力和张应力么？
来自互联网
12. When the tensileload is not perpendicular to the twin boundary, the yield stress decreases and the deformation is mainly detwinning.
拉伸载荷与孪晶界不垂直时，屈服应力降低，变形方式则以去孪晶为主。
来自互联网
13. And elementary researches have been made in identifying axial tensileload, for which reason more proper identifying purpose has been gained compared with...
并利用压电智能夹层进行了初步的拉伸载荷识别，同压电片相比，识别效果更明显。
来自互联网
14. The time history curves and the phase diagram for the oscillation are obtained by solving the differential relation between vibration amplitude and tensileload with finite difference method.
应用有限差分法求解球壳振动的振幅和外加荷载之间的微分关系，得到了球壳振动的时程和相图。
来自互联网
15. A study of crack prevention under tensileload is performed on an aluminum alloy 2a12 specimen with an oblique spatial crack by using electromagnetic heating online.
选择带有空间斜裂纹的2a12铝合金试件进行了拉伸载荷作用下电磁热在线止裂研究。
来自互联网
16. The experimental results show that the types of crack initiation at inclusion in ultrahigh strength steel under tensileload depend on the sizes of inclusion and the hole around inclusion.
结果表明，拉伸载荷作用下，航空用超高强度钢中裂纹萌生的方式与夹杂物尺寸及夹杂物周围孔洞的大小有关。
来自互联网
17. Equipped with electronic tensile testing machine, load device can be thought of in the standard given by the chapter 9 test speed completely without inertia.
装有电子测力装置的拉力试验机，可以认为在标准第9章所给出的各试验速度下完全无惯性。
来自互联网
18. In Chapter 5, problem of radial motion for a solid sphere composed of an imperfect incompressible hyper-elastic material, subjected to a surface tensile dead load, is examined.
第五章中，研究了具有缺陷的不可压超弹性材料组成的球体在表面均布的拉伸死载荷作用下的径向运动问题。
来自互联网
19. When the tensile strain reaches the limit load, the force of tension suddenly becomes very small, because clusters structures change.
当拉伸应变达到承载极限，继续拉伸，力突然变的很小，这是因为团簇发生了结构变化。
来自互联网
20. The interrelation coefficients of point load test index to its compressive and tensile strength are finally recommended.
提出了点荷载指标与抗压强度及抗拉强度间的相关系数。
来自互联网
21. The limit load formulae of single-edge deeply notched plates with round ends subjected to pure bend moment and tensileload under plane stress condition have been derived.
推导了平面应力条件下单边圆形底部深缺口板条受纯弯曲和拉伸载荷作用的极限载荷公式。
来自互联网
22. Diametral point load test is a very promising, simple and accurate method for obtaining compressive and tensile strength data of rock core.
用岩芯进行径向点荷试验，是简单而较精确地获得岩石抗拉、抗压强度的极有前途的方法。
来自互联网
23. The ultimate tensileload of the 3D braid increases significantly by incorporating PGA fibers into the braiding yarn.
在编织纱中掺入PGA纤维，可显著提高三维编织物的最大拉伸裁荷；
来自互联网
24. The uneven distribution of loading, the clamping damage and the stress concentration were thought to be the three key factors influencing the fatigue test of steel strand with pulsating tensile load.
受力不均、夹持损伤和应力集中是影响钢绞线脉动拉伸疲劳试验的三个关键问题。
来自互联网
25. Based on the reduced calculation to dynamic and static load, the article analyzes the tensile force and additional dynamic load which the chain stands in the movement.
基于实际中对动静张力的折合计算，分析了链条在运动过程中所受张力及附加动载荷。
来自互联网
26. The design of a new pre-tensional structure (FROMOpreload nut) applied in the large size of screw thread was introduced, the pre-load bolt is only beared with the pure tensile stress.
介绍了一种应用于大规格螺纹预紧的新型结构FROMO预紧螺母的结构设计，该结构螺栓只承受纯拉应力。
来自互联网
27. The experimental results reveal that the tensile strength and deformation properties of the Inada granite vary with the direction of tensileload.
结果表明，稻田花岗岩的抗拉强度和变形常数随拉应力的作用方向不同而发生明显变化。
来自互联网
28. This paper describes the significance and role of the initial test load holding time in the tensile stress relaxation test at room temperature for the pre-stressed rolled steel.
本文探讨了预应力钢材常温拉伸应力松弛试验中，初始试验力保持时间的意义与作用。
来自互联网
29. Based on the calculation to the common calculating chain force, this article analyzes the tensile force and additional dynamic load which the China of mould-cutting machine stands in the movement.
基于一般链传动的受力计算，分析了模切机链条运行过程中所受的张力和附加动载荷，可供设计时参考。
来自互联网
30. Based on the calculation to the common calculating chain force, this article analyzes the tensile force and additional dynamic load which the China of mould-cutting machine stands in the movement.
