Taper roller bearing race, a very important load-bearing component, has significant affection on the property of the bearing.
来自互联网
16. 在铜管上安装阀门，然后轻轻地把压缩螺母和套圈移到阀门上并进行啮合。
Install the valve onto the copper tube and gently slide compression nut and ferrule up to the valve to engage.
来自互联网
17. 以试验为基础，研究30204圆锥滚子轴承套圈参数与振动速度的关系。
Based on the experiment, the relation between ring parameter and vibration velocity of 30204 tapered rolling bearing is studied.
来自互联网
18. 易之间的管材，管件常设大会：推入拟合套圈油管，直到管“点击”到位。
Easy, permanent assembly between the tubing and fittings: push the tubing over the fitting ferrule until the tubing "clicks" into place.
来自互联网
19. 介绍了圆锥轴承套圈精密辗扩机的结构、控制原理及各主要组成部分的设计特点。
The structure, control principle and main part design features are introduced for precision rolling machine of the tapered bearing ring.
来自互联网
20. 在磨削套圈沟道工序中，沟道磨削余量的大小对加工效率和表面质量影响非常大。
In the working procedure of grinding grooved raceway of the RACES, grinding stock removal of grooved raceway has an important effect on processing efficiency and surface quality.
来自互联网
21. 针对双滚道滚动轴承套圈磨削加工过程中存在的问题，提出了动态控制磨削加工法。
Pointing at problems produced in grinding process of bearing rings with double raceways, the dynamic control grinding process method is put forward.
来自互联网
22. 针对短时间内大量轴承套圈突然生锈的情况，分析了产生锈蚀的原因，提出了预防措施。
Because large quantity of bearing rings rusted in a short of time, the reason of causing rust was analyzed and preventive measures were given.
来自互联网
23. 对单列角接触轴承，径向额定负荷为引起轴承套圈彼此相对纯径向位移的负荷的径向分量。
On the single row angular contact bearings, radial load rating of bearing rings relative to each other purely radial displacement of the load of the radial component.
来自互联网
24. 管道管件应为非扩口压缩式三件构造，由套圈、螺帽和本体组成，适宜安装在不锈钢管道上。
Tube fittings shall be flare less compression type of three-piece construction consisting of ferrule nut and body suitable for use on ss tubes.
来自互联网
25. 每个切削端都具有在其末端的切削头，主体部分，主体部分中的凹口以及定位于凹口中的套圈。
The cutting ends each have a cutting tip at a distal end, a body portion, a recess in the body portion and a retainer positioned in the recess.
来自互联网
26. 每个切削端都具有在其末端的切削头，主体部分，主体部分中的凹口以及定位于凹口中的套圈。
The cutting ends each have a cutting tip at a distal end, a body portion, a recess in the body portion and a retainer positioned in the recess.
