1. Many times (as with pinion gears) you will need to remove small setscrews (typically 3mm) that have been tightened as much as possible.
很多时候(与小齿轮)，你将需要删除的小定位螺丝(通常为3毫米)已拧紧尽可能。
youdao
2. At one end of the inner ring, the bearing is clamped to the shaft with an eccentric locking ring (Figure 1.7) or with two setscrews (Figure 1.8).
在内圈的一端，轴承通过偏心锁定环(图1.7)或者两个定位螺钉(图1.8)被固定在轴上。
youdao
3. Trying to remove these setscrews with a hex wrench (aka Allen wrench) that is the wrong size or even slightly worn will very likely strip the drive cup of the setscrew.
4. Trying to remove these setscrews with a hex wrench (aka Allen wrench) that is the wrong size or even slightly worn will very likely strip the drive cup of the setscrew.
