1. 通过对轴流轮流固耦合的数值模拟,得到了轮内部真实流动情况和内部应力分布情况。
We can obtain the impeller's interior actual flow situation and the impeller internal stress distribution due to axial flow fluid-solid coupling numerical simulation.

youdao

2. 洒水车水壳出现裂纹、或者轮、倒损坏、或者水封破损,都会影响真空度,出现水抽不上来,或者水压过小的现象。
Sprinkler pump shell cracks, or impeller, leaf damage, or seal damage, will affect the degree of vacuum, water pumping, water pressure is too small or the phenomenon.

youdao

3. 热点项目包括心肌组织的组织工程模型、三瓣、细胞型的心脏及血管移植物。
Active programs include tissue engineering models for cardiac muscle tri - leaflet valves cell-based cardiac pumps and vascular grafts.

youdao

4. 压水室采用导式结构能够尽快地把液体的动能转换为压力能,同时能够使腔内的流动更趋合理均匀,提高内气液分离的能力,并且能平衡轮径向力。
The volute of guide-vane structure can transform the kinetic energy to pressure energy as soon as possible, and improve the capacity of separating gas and liquid for the more balance flow in it.

youdao

5. 用多箔片轴承取代火箭发动机涡轮上的滚珠轴承具有工作寿命长、工作转速高、能量损失小等重要优点。
Multileaf foil bearing, instead of ball bearing of turbo-pump in rocket engine, has many important advantages including long life, high speed and low energy loss.

youdao

6. 对大改造保留出口导轮改型方案作了深入的探讨。
A reform scheme with exit guide vane remained for large axial flow pumps is discussed deeply.

youdao

7. 轮和导是轴流装置中的重要过流部件,而轴流后导(以下简称导)是内动能回收的主要部件。
Impeller and diffuser are important parts in the Axial-flow pump and the later is the important part to take back energy.

youdao

8. 转子的转子数可能是两或三
Number of lobe of rotor in rotating pump may be two or three.

youdao

9. 采用径向导的液氢的试验结果表明,导损失大,导致液氢效率低。
The results, which obtained by using radial diffuser, show that due to the high loss through the diffuser, the efficiency of the liquid hydrogen pump is lower.

youdao

10. 对酮苯装置-19轮腐蚀进行了失效分析。
The corrosion failure of the blades of Pump-19 in the acetone-benzol plant was analyzed.

youdao

11. 水力部件由以下组成:出入口管,壳体,法兰,轮,导轴,轴承,热屏和热屏热交换器。
The hydraulic section consists of the inlet and outlet nozzles, casing, flange, impeller, diffuser, pump shaft, pump bearing, thermal barrier and thermal barrier heat exchanger.

youdao

12. 本文成立了多级离心内部流场的计较模子,体例了活动计较措施。
This paper sets up a calculation model to solve the internal flow of multistage centrifugal pumps and a flow calculation program is worked out.

youdao

13. 本文介绍了离心节能的主要技术,并提出了前置导预旋调节的节能技术。
This paper introduces the main energy saving technologies of centrifugal pump. And the author proposes a new energy saving technology which is called prerotation regulated by the inlet guide vane.

youdao

14. 通过对三外环流活塞工作原理的研究,得出了它的封液条件和不干涉条件,并给出了设计方法和有关公式。
The operating principle of three--vane external circulating current piston pump was studied and the conditions of liquid seal and non--interferrence of the pump were got.

youdao

15. 针对轴向柱塞故障特征的模糊性和不完备性特点,提出一种多特征信息融合与贝斯网络相结合的故障诊断方法。
Aiming at the fuzzy and incomplete nature of fault characteristics of axial piston pump, a method of Bayesian networks and multi-characteristic information fusion was proposed.

youdao

16. YB_1—100存在噪声高,压力脉动大,性能稳定性差的问题。
The present problems of YB_1-100 vane pump are high noise, large pressure pulse and poor stability.

youdao

17. 靠近出口的两个道内,有气相的积聚,含气率较高。
The two channels near the outlet of the pump have obvious gas accumulation with higher gas voids.

youdao

18. 进水口过滤网设计,防止杂物进入损坏水或导致马达烧坏。 ★本浦马达采用环氧树脂防腐涂层,不易生锈。
Inlet suction strainer design avoids impeller and motor damages by foreign substances. Anticorrosive epoxy coating on pumps makes antirust available.

youdao

19. 进水口过滤网设计,防止杂物进入损坏水或导致马达烧坏。 ★本浦马达采用环氧树脂防腐涂层,不易生锈。
Inlet suction strainer design avoids impeller and motor damages by foreign substances. Anticorrosive epoxy coating on pumps makes antirust available.

youdao