Under the condition of different furnace type and coking time, influence of banking time of coke oven on coke thermal state performance is studied.
youdao
2. 在本章节最后，我们计算了二粒子海森堡模型在热态下的保真度。
At the end of this chapter, we calculate the quantum fidelity of Heisenberg Model with two particles under thermal state.
youdao
3. 在自行设计的电磁抗垢实验装置上，对热态工况下低频电磁抗垢(EAF)技术进行了实验考察。
The low frequency electromagnetic anti-fouling (EAF) technology was discussed on the basis of the experiment device devised by ourselves in the situation of heat state.
youdao
4. 环氧-羧酸盐体系虽然热变形温度和热态强度较高，但高温下介电性能差，耐热老化性能也不好。
The cured system of epoxy resinlead benzoylate has high heat distortion temperature, but its dielectric properties at high temperature and heat ageing life deteriorate.
youdao
5. 针对工业装置运行中的实际问题，在综合热态流化床实验台上研究了不同运行参数下石英砂的磨损规律。
Referring to some problems in industrial devices, the attrition of quartzite particles at various operational parameters in a hot fluidized bed was investigated.
youdao
6. 在此基础上，研究了热真空态下各支路电流和电压的量子涨落。
On this basic theory, we have studied quantum fluctuations of the voltage and current of each branch in thermal vacuum state.
The visible light absorption curve and heat recovery curve of mercuric and zinc dithizone in PMMA and PS are also measured.
youdao
8. 在真空态和热真空态下讨论了介观RLC电路的量子涨落。
The quantum fluctuations of mesoscopic RLC circuit in vacuum state and in thermal vacuum state are considered.
youdao
9. 最后指出要满足燃烧的要求，W形火焰锅炉的风速、煤粉调平工作必须在热态下进行。
Finally, it is indicated that the air velocity and pulverized coal concentration uniformity regulating in W-firing boilers should be carried out in hot position to meet the demand of combustion.
youdao
10. 研究了在常规炼焦工艺及肥煤、焦煤比例相对稳定条件下，望峰岗煤的性质对焦炭热态性能的贡献。
Under the normal coking process and the regular blend with constant proportion of coking coal and fat coal, the property of WangFengGang coal and its influence on metallurgical coke were studied .
youdao
11. 分析方坯产生凸台的原因，为改善铸坯质量，减少横梁在热态下的变形位移量，并进行检测、论证。
This paper analyses the reasons of convex side on blooms. For improving the bloom quality, the method to reduce hot strain and displacement of the cross beam has been adopted and tested.
youdao
12. 结合实验研究的结果对冶炼过程中烧结矿在冷态和热态下的破损机理分别进行了剖析。
Finally the sinter damage mechanism under normal temperature and high temperature during smelting in blast furnace is analyzed with the experimental results.
youdao
13. 对原始组织为铸态和热轧态的2205双相不锈钢试样进行了不同条件下的固溶处理热模拟试验。
The solution treatments were performed with the specimens of 2205 duplex stainless steel, which possessed different initial microstructures.
A new propulsion concept of 2 D C D vectoring nozzle was proposed, which had a convergent duct shaped by spheric surface and a divergent one with rectangular transverse section.
